TRANSLUCENT RED HOT DIP (CASE-50)

Protective Coating Red-Hot-Dip

Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits

• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years

• Easy part identity through the translucent coating

• Simple to remove by peeling off

• Once removed, leaves behind a thin oil film to provide short term protection against corrosion

• Removed coatings may be reused saving cost

Notes

• Each single block measures (L)-150mm (H)-50mm (W)-80mm

• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings

• Never directly apply heat to melt the protective dip

• Always use with a suitable melting pot